Radius Strong, versatile belt with small holes, 42% open area and a 2.2 turning radius. Durable and easy to clean. Small pitch allows tight transfers for delicate products.
Tight Turning Radius
Same interior design as series 2400 Radius (2.2 turning version), but with edge modules that collapse tighter, allowing for down to a 1.7 turning radius up to 24” wide (18” wide in spiral applications). Contact customer service for specific conveyor requirements.
Radius Friction Top
Friction top modules can be built into either turning radius version. Rubber is bonded to the top surface of interior modules and provides a friction top surface for inclines and declines.
Tight Turning Radius with Roller Inserts
Designed for low back pressure accumulation in applications requiring a radius belt. Offers 42% open area and a 1.7 turning radius up to 24” wide (18” wide in spiral applications). Wide roller-to-rod contact area means less wear.
Radius with Roller Inserts
Designed for low back pressure accumulation in applications requiring a radius belt. Offers 42% open area and a 2.9 turning radius. Wide roller-to-rod contact area means less wear. NOTE: belt strengths are for 3” roller width spacing.
Molded sprockets are available in the following nom. pitch diameters: 6 tooth, 2.0″ (51 mm); 9T, 2.9″ (74 mm); 12T, 3.9″ (99 mm); 16T, 5.1″ (130 mm) and 20T, 6.4″ (163 mm). Round bore sizes also available.
Intralox 3” (76 mm) No-Cling Flights for Series 2400. The flight’s “ridges” are part of the No-Cling design which reduces product sticking to improve yield.
Hold Down Guide
Guide is on the bottom of the belt for use when the belt edges need to be clear. The hold down guide steers the belt through the turns and holds it in place vertically.
Universal and Clip-On Sideguards assure product containment in high speed and general spiral applications and incline/decline applications. The Universal Sideguard is available in 1” (25 mm) and 3” (76 mm), and is an integral part of the belt, fastened by hinge rods. The Clip-On Sideguard snaps into the belt’s edge modules with 2.2 turn ratio and is available in 0.75” (19 mm).