Intralox Series 1100

Flush Grid USDA accepted for meat and poultry. Mini-pitch 0.6" (15.2 mm) nom. has low chordal action for a smooth running belt. Mesh top with 28% open area. Headless rod retention system allows re-use of rods.	Flat Top USDA accepted for meat and poultry. Mini-pitch 0.6" (15.2 mm) nom. has low chordal action for a smooth running belt. Headless rod retention system allows re-use of rods.	Flush Grid Friction Top Combines benefits of high friction top surface with modular plastic design. Mini-pitch and lightweight design offer smooth conveyance.
Perforated Flat Top USDA accepted for meat and poultry. 3.2% open area. Underside design and small pitch allows the belt to run smoothly around nosebars.	ONEPIECE™ Live Transfer Flush Grid Nominal 0.6" (15.2 mm) mini-pitch belt with fully flush edges. Facilitates smooth, self-clearing, right angle transfers onto takeaway belts. Lightweight with smooth surface grid and molded tracking tabs.	Flush Grid Nub Top Nub Top pattern creates a lifting effect that reduces surface contact between belt and product; eliminates the tendency of product to suction to the belt surface. Promotes quicker, easier product release. 15% open area provides dewatering capabilities.

Accessories
	Molded and Split Sprockets Intralox offers molded sprockets with 12, 16, 18, 20, 24, 26 or 32 teeth, and single plate stainless steel sprockets with 8 or 12 teeth. Intralox also offers split sprockets with stainless steel tooth-bearing plates sandwiched between bore-specific polypropylene hubs. Intralox can machine sprockets with different numbers of teeth if the application cannot use standard sizes.
	SPROCKETS            NOM. PITCH DIAM.      8T                        1.6" (41 mm)      12T                      2.3" (58 mm)      16T                      3.1" (79 mm)      18T                      3.5" (89 mm)      20T                      3.8" (97 mm)      24T                      4.6" (117 mm)      26T                      5.1" (130 mm)      32T                      6.1" (155 mm)
	Sideguards Sideguards are used to assure product containment and are available 2'' (51 mm) high. Made in the standard overlapping design, they are an integral part of the belt and are fastened by the hinge rods.
	Streamline Flights These 2'' high (51 mm) streamline flights can be cut down to any height. Each flight rises out of the center of its supporting module, molded as an integral part, and is secured by hinge rods.
	Flush Grid Nub Top Base Flights The Nub Top Flight is available in a 2'' (51 mm) height. The No-Cling vertical ribs are on both sides of the flight. Flights can be cut down to any height requirement. Available in Polypropylene, Polyethylene, and Acetal.